Maintenance method of chain block after rain

 


   Rainwater is a corrosive gas in the air. Generally speaking, it is a combination of easily soluble substances and water vapor. The main body of corrosive objects in the air is acidic. Because the rainwater itself is acidic, once the Chain block is exposed to rainwater for a long time, Will increase the possibility of chain block corrosion, which will cause the chain and parts to rust.

   The correct way is to dry and dry the parts after being exposed to rain. It is best to use a hair dryer to dry the parts. If the internal parts cannot be completely blown dry, then you can disassemble the Chain block cover and air it, and wait until it is completely dry. Secondly, apply anti-corrosion grease or lubricating oil to the corrosive parts.

chain block

   After the above steps, a safe trial run is required next time it is used, and it can be used normally. After normal treatment, the Chain block has basically no obvious impact, but it is still necessary to reduce the number of times the Chain block is exposed to rain.


Disclaimer: This article is reproduced from other media. The purpose of reprinting is to convey more information. It does not mean that this website agrees with its views and is responsible for its authenticity, and does not bear any legal responsibility. All resources on this site are collected on the Internet. The purpose of sharing is for everyone's learning and reference only. If there is copyright or intellectual property infringement, please leave us a message.
©Copyright 2009-2020 Yahoo Perspective   cryydr@163.com   Contact Us   SiteMap